Online Supplier of Flue Pipe, Chimney Parts & Accessories

Flue Pipe, Chimney Parts & Accessories

Chimney Register Plate 900mm x 495mm

£53.99

In stock

APPLICATION
Suitable for gas, oil and solid fuel appliances with temperatures up to 750 degrees C.
Stove pipe should only be used as a connecting pipe between your appliance and Flue Liner / Chimney Stack / Twin Wall Flue System.
Black stove pipe should NOT be used to pass through a ceiling or wall, twin wall insulated flue pipe should be used.

CONSTRUCTION
Black stove pipe is a single skin flue system manufactured in zero carbon steel with vitreous enamel coating in a matte black finish.
Suitable for gas, oil and solid fuel appliances with temperatures up to 750 degrees C

INSTALLATION
You should not install a piece of Black Stove Pipe within 3 times the diameter of the flue from combustible material, e.g. wood, plaster boards, etc.
A 5 inch (125mm) diameter piece of FLUE should be 400mm away from combustible materials.
When installing make sure Black Stove Pipe is installed the correct way up – the smaller diameter should always be pointing downward.
This is because all the condensates will stay within the flue system and not pass to the outside of Black Stove Pipe.
Each joint should be coated with a jointing compound (fire cement or high temperature silicone sealant).This makes sure that no condensate can escape and spoil the appearance of the pipe.

MAINTENANCE
You should make provision for inspecting and cleaning the chimney. This is particularly important on solid fuel applications.
You can achieve this by installing a black pipe with an access door.
It is recommended that chimneys serving solid fuel appliances be swept and maintained as frequently as necessary but at least once a year.

In stock

Description

Chimney Register Plate 900mm x 495mm

Chimney Register Plates are used to seal off the base of the chimney.
This Register Plate is 900mm x 495mm
Comes Supplied with 4 x angle mounting brackets (fixing screws not included)
It is suitable for 125mm and 150mm (5 and 6 inch) Black Stove Pipe.

Hole Diameter: 5 inches and 6 Inches – fitted with a removable plate to facilitate either 5″ or 6″ pipe

APPLICATION
Use to seal off the base of the chimney (This Register Plate can be cut on site to fit the base size of your chimney stack). The Register Plate will support vermiculite and stop any debris from within the chimney stack coming down the chimney and hitting your stove.

CONSTRUCTION
The Register Plate and the Supporting Brackets are made from 1.5mm thick galvanised steel. The Register Plate can be sprayed to match the colour of your stove pipe. This Register Plate has a special adaptor suitable for installations which use either 125mm or 150mm diameter flue pipes.

INSTALLATION
The four supporting brackets should be cut to the length and width of the base of your chimney stack. Drill a number of holes in the brackets. Now screw them into the brickwork. Cut the Register Plate to the correct size, taking care that the pipe hole lies vertically above the Black Stove Pipe. Drop the Register Plate onto the supporting brackets. Now seal any gaps between the brickwork and the brackets / plate using Fire Cement or High Temperature Sealant. For 150mm diameter installations simply remove the centre cover ring by unscrewing the two retaining screws.

Chimney Register Plate 900mm x 495mm

This website uses cookies and third party services. OK
Go to Top